Remote Engine Start Function Does Not Operate: Description

Engine does not start when operating REMOTE ENGINE START button of Intelligent Key.

NOTE: Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.

Conditions of Vehicle (Operating Conditions) 

• Shift position is in P position.
• Vehicle security system is not in operation.
• Registered Intelligent Key is not in the vehicle.

NOTE: Supplemental Diagnosis Table - RES does not work

	POSSIBLE CAUSE	RESOLUTION
1.	The ECM has not completed the shutdown procedure after the engine/ignition was OFF.	Wait six (6) seconds after the engine/ignition has been OFF before attempting RES.
2.	The RES was correctly activated two (2) times consecutively. Or, the RES was activated once and while the engine was running, another RES request was generated.	Drive the vehicle over 5 mph (7 km/h) to reset the RES counter.
3.	The doors and hatch are not closed and locked.	Close and lock all doors and hatch. Confirm both conditions in BCM Data Monitor: All doors closed - Status SW = OFF. All doors locked - Status = LOCK.
4.	The lock button on the Intelligent Key was not pressed prior to activating the RES.	Press the lock button before pressing and holding the RES button.
5.	The RES button on the Intelligent Key was not held long enough.	Hold the RES button for more than two (2) seconds to activate RES.