Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

GO TO 2.

1. Start the engine, and warm it up until the following condition is satisfied.

   Engine coolant temperature	65 Deg. C (149 Deg. F) or more
   Engine oil temperature	80 Deg. C (176 Deg. F) or more

2. Move the vehicle to a cool place.
3. Stop the engine, and cool it down until the following condition is satisfied.

   Engine coolant temperature	50 Deg. C (122 Deg. F) or less
   Engine oil temperature

   CAUTION: Never turn ignition switch ON during soaking.
4. Start engine and let it idle for 5 seconds or more.
   CAUTION: Never turn ignition switch OFF during idling.
5. Check 1st trip DTC.

Is DTC P2587 detected?

YES

Refer to DTC Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Inspection .

NO

Confirmation after repair: INSPECTION END