LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2021 >> QX80 Premium Select, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (5 Of 5) >> Engine (ECM) >> DTC P2610: ECM Internal Timer >> Confirmation Procedure

Confirmation Procedure

  1. INSPECTION START 

    It is necessary to erase permanent DTC?

    YES

    GO TO 4.

    NO

    GO TO 2.

  2. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 12 V or more under ignition switch OFF condition.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE-I 
    1. Turn ignition switch ON and wait at least 190 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

  4. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    • Before performing the following procedure, confirm that battery voltage is 12 V or more under ignition switch OFF condition.
    • Before performing the following procedure, check that fuel level is between 2/8 and 7/8.

    GO TO 5.

  5. PERFORM DTC CONFIRMATION PROCEDURE-I 
    1. Turn ignition switch ON and wait at least 190 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    GO TO 6.

  6. PERFORM DTC CONFIRMATION PROCEDURE-II 
    CAUTION: To start this self-diagnosis, the conditions listed bellow are required to be satisfied. Perform the following steps to satisfy the conditions.
    • Engine coolant temperature decrease by 55 deg.C (131 deg.F) or more during the time between an ignition switch OFF (after engine warm-up) and the second ignition switch ON.
    • A fuel temperature at the second ignition switch ON is -5 deg.C (23 deg.F) or more and less than 35 deg.C (95 deg.F).
    • The temperature difference between engine coolant and fuel is 5 deg.C (41 deg.F) or more.
    NOTE: This self-diagnosis is not performed if the distance traveled is extremely short.
    1. Turn ignition switch ON.
    2. Start engine and warm it up to normal operating temperature.
    3. Turn ignition switch OFF and soak the vehicle for at least 14 hours.
      CAUTION:
      • Never turn ON the ignition switch during soaking.
      • Never open the fuel filler cap and perform refueling during soaking.
    4. Turn ignition switch ON and wait at least 190 seconds.
    5. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals