Diagnosis Procedure

CONSULT

1. Start the engine.
   CAUTION: Never drive the vehicle.
2. On the CONSULT screen, select "DAST 1">>"DATA MONITOR">>"C/M TEMPERATURE".
3. Wait with the ignition switch OFF until the data monitor indication becomes between -40 deg. C (-40 deg. F) and 150 deg. C (302 deg. F).

Does the temperature become between -40 deg. C (-40 deg. C) and 150 deg. C (302 deg. F)?

YES

GO TO 2.

NO

Replace steering angle main control module. Refer to Removal and Installation .

CONSULT

1. Ignition switch ON.
2. Erase "Self Diagnostic Result" mode of "DAST 1".
3. Ignition switch OFF and wait for at least 10 seconds.
4. Start the engine.
   CAUTION: Never drive the vehicle.
5. Select "Self Diagnostic Result" mode of "DAST 1".

Is DTC "C13DE-00" detected?

YES

Replace steering angle main control module. Refer to Removal and Installation .

NO

• Check enlarged contact spring of terminal. Refer to How to Check Terminal .
• Perform intermittent incident while turning steering wheel. Refer to Intermittent Incident .