LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2021 >> Q60 Pure, RWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Body Control System (Diagnostics) >> Basic Inspection >> Body Control System >> Additional Service When Replacing BCM >> Work Procedure >> After Replacement

After Replacement

CAUTION: When after replacing BCM, always perform "Operation Log Selection" or "Manual Configuration" with CONSULT. Or not doing so, BCM control function does not operate normally.
  • Complete the procedure of "Re/programming, Configuration" in order.
  • Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  • If you set incorrect "Vehicle Configuration", incidents might occur.
  1. SAVING VEHICLE SPECIFICATION (BCM) 

    SYMBOL CONSULT Configuration

    1. Select "Re/programming, Configuration".
    2. Select the operation according to the CONSULT screen.
    3. Perform "Before ECU Replacement" of "Vehicle Configuration" to write vehicle specification.
    NOTE: If "Before ECU Replacement" of "Vehicle Configuration" cannot be used, use the "Manual Configuration" after replacing BCM. Refer to Refer to Work Procedure .

    GO TO 2.

  2. SAVING VEHICLE SPECIFICATION (TPMS) (IF EQUIPPED) 

    Perform saving vehicle specification (TPMS). Refer to Work Procedure .

    GO TO 3.

  3. REPLACE BCM 

    Replace BCM. Refer to BCM : Removal & Installation .

    GO TO 4.

  4. WRITING VEHICLE SPECIFICATION (BCM) 

    SYMBOL CONSULT Configuration

    Select "Re/programming, Configuration". Refer to Refer to Work Procedure .

    GO TO 5.

  5. INITIALIZATION AND REREGISTERING OF ALL KEYS 

    Perform initialization and re-registration of all keys: Refer to CONSULT Immobilizer mode and follow the on-screen instructions.

    GO TO 6.

  6. WRITING VEHICLE SPECIFICATION (TPMS) (IF EQUIPPED) 

    Perform writing vehicle specification (TPMS). Refer to Work Procedure .

    WORK END

scientia non olet · About LEMON Manuals