LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2021 >> Q60 Pure, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (1 Of 7) >> Engine (ECM) >> DTC P0106: Manifold Absolute Pressure Sensor >> Confirmation Procedure

Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Accelerate the vehicle from 40 km/h (25 MPH) to 70 km/h (44 MPH) or more within 7 seconds.
      CAUTION: Always drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
      NOTE: Keeping the accelerator pedal as steady as possible at approximately 3/8 during the acceleration allows easy diagnosis.
    2. Check 1st trip DTC.

    Is DTC P0106 detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals