Wake-up operation
WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- BCM transmits sleep wake up signal (wake up) to each unit when any condition listed below is established, and then goes into normal mode from low power consumption mode.
- Each unit starts transmissions with CAN communication by receiving sleep wake up signals. Each unit transmit wake up signals to BCM with CAN communication to convey the start of CAN communication.
Wake-up condition
|
BCM wake-up condition
|
CAN wake-up condition
|
|
Back door opener switch: OFF - ON
|
- Receiving the sleep-ready signal (Not-ready) from any units
- Push-button ignition switch (push switch): OFF - ON
- Hazard switch: ON
- HI BEAM switch: OFF - ON, ON - OFF
- PASSING switch: OFF - ON, ON - OFF
- HEADLAMP 1 switch: OFF - ON, ON - OFF
- HEADLAMP 2 switch: OFF - ON, ON - OFF
- TAIL LAMP switch: OFF - ON
- FR FOG switch: OFF - ON, ON - OFF
- TURN RH: OFF - ON, ON - OFF
- TURN LH: OFF - ON, ON - OFF
- Driver door switch: OFF - ON, ON - OFF
- Passenger door switch: OFF - ON, ON - OFF
- Rear RH door switch: OFF - ON, ON - OFF
- Rear LH door switch: OFF - ON, ON - OFF
- Back door switch: OFF - ON, ON - OFF
- Driver door request switch: OFF - ON
- Passenger door request switch: OFF - ON
- Back door request switch: OFF - ON
- Stop lamp switch: ON
- Door lock and unlock switch:
NEUTRAL - LOCK, NEUTRAL - UNLOCK
- Door key cylinder switch:
NEUTRAL - LOCK, NEUTRAL - UNLOCK
- Remote keyless entry receiver communication: Receiving
- Front door lock assembly (driver side) (unlock sensor):
OFF - ON, ON - OFF
|