Work Procedure
- WRITING MODE SELECTION
CONSULT Configuration
Select "Re/programming, Configuration" of "MULTI AV".
When writing saved data
GO TO 2.
When writing manually
GO TO 3.
- WRITING VEHICLE SPECIFICATION
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to display control unit.
CAUTION: Do not perform any operation such as the navigation operation during configuration writing.GO TO 4.
- WRITE VEHICLE SPECIFICATION
Select "Manual Configuration", and write the setting value as shown in the following table to display control unit according to the vehicle specification.
CAUTION: Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM
Detail
Items
Setting value
NAVIGATION
WITH
Models with navigation
WITHOUT
Models without navigation
RSE
WITH
Models with mobile entertainment system
WITHOUT
Models without mobile entertainment system
CAMERA SYSTEM
NONE/AVM/ph3
Models with intelligent around view monitor system
REAR
Models with rear view monitor system
LDP (LANE DEPARTURE PREVENTION)
Off
Models without lane departure prevention (LDP) system
On
Models with lane departure prevention (LDP) system
DESTINATION
U.S.A.
For United States of America
Canada
For Canada
China
--
Russia
--
Australia
--
Mexico
For Mexico
LAM
For Latin America
GCC
For The Middle East
Asia
--
REGION CODE
TYPE 1
--
TYPE 2
TYPE 3
TYPE 4
TYPE 5
TYPE 6
GO TO 5.
- PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of CONSULT, and check whether or not DTC U1223 is detected.
Is DTC U1223 detected?
YES
GO TO 3.
NO
GO TO 5.
- OPERATION CHECK
Check that the operation of the display control unit and camera images (fixed guide lines and predictive course lines) are normal.
Work End.