Component Inspection

With CONSULT

1. Turn ignition switch OFF.
2. Reconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
4. Turn ignition switch ON.
5. On CONSULT, select "ENGINE">>"Active Test">>"ENGINE MOUNTING".
6. Check air passage continuity and operation delay time under the following conditions.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Condition (ENGINE MOUNTING)	Air passage continuity between and	Air passage continuity between and
   TRVL	Existed	Not existed
   IDLE	Not existed	Existed

Without CONSULT

1. Turn ignition switch OFF.
2. Disconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
4. Check air passage continuity and operation delay time under the following conditions.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Condition	Air passage continuity between and	Air passage continuity between and
   12 V direct current supply between terminals 1 and 2	Existed	Not existed
   No supply	Not existed	Existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace electronic controlled engine mount control solenoid valve. Refer to VALVE TIMING CONTROL .