LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2019 >> Q50 Pure, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (1 Of 2) >> Basic Inspection >> How To Erase Permanent DTC >> For MEXICO >> Work Procedure

Work Procedure

  1. CHECK DTC 

    Check DTC.

    Is any DTC detected?

    YES

    Repair malfunction(s) and erase DTC. Refer to Diagnosis Description  or CONSULT Function .

    NO

    GO TO 2.

  2. CHECK PERMANENT DTC 

    SYMBOL With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    SYMBOL With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

    Is any permanent DTC detected?

    YES

    GO TO 3.

    NO

    END

  3. DRIVE DRIVING PATTERN 

    Drive the vehicle 3 times under the following conditions.

    1. Turn ignition switch ON.
    2. Drive the vehicle and maintain the following conditions.
      • Engine speed reaches 400 rpm or more.
      • Engine coolant temperature reaches 70 deg.C (158 deg.F) or more.
      • Vehicle speed of 70 - 120 km/h (44 - 75 MPH) is maintained for 60 seconds or more under the control of closed loop.
      • Vehicle speed of 30 - 60 km/h (19 - 37 MPH) is maintained for 10 seconds or more under the control of closed loop.
      • Under the closed loop control condition, the following state reaches 12 seconds or more in total: Vehicle speed of 4 km/h (2 MPH) or less with idling condition.
      • The state of driving at 10 km/h (7 MPH) or more reaches 10 minutes or more in total.
      • A lapse of 22 minutes or more after engine start.
    3. Turn ignition switch OFF.
    NOTE: Drive the vehicle at a constant velocity.

    GO TO 4.

  4. CHECK PERMANENT DTC 

    SYMBOL With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    SYMBOL With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

    Is any permanent DTC detected?

    YES

    GO TO 1.

    NO

    END

scientia non olet · About LEMON Manuals