LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> QX80 RWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Driveline System (DTCS) >> All Mode AWD/4WD (Transfer Control Unit) >> DTC P1808: Wheel Speed Sensor >> Confirmation Procedure

Confirmation Procedure

  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. DTC REPRODUCTION PROCEDURE 

    SYMBOL With CONSULT

    1. Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
    2. Perform self-diagnosis for "ALL MODE AWD/4WD".

    Is DTC "P1808" detected?

    YES

    Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals