Work Support

Work support item	Description
TEACH IN COMBINATION METER	-- NOTE: This item is performed automatically by configulation of CONSULT.
TABLE INITIALIZATION ASSYST	This is an assist function that calculates the new service interval in the background if parameters were changed before (e.g. oil grad factor change). NOTE: This item is performed automatically by configulation of CONSULT.
TRANSFER OF MANUFACTURER DEFAULT SETTINGS	This function sets all parameters in the combination meter to default values.
CHECK CONTROL UNIT STATUS	This function checks whether the control unit is in bootloader status.
Re learning	This function reads the odometer value and the vehicle key ID from the electronic ignition switch control unit and writes the information to new combination meter.
Oil grade factor	The oil grade factor can be set after an oil change and according to this factor the service interval will be calculated.
Service interval settings	Actuation after oil change. If the oil grade factor were entered and when this factor was incorrect, there is an opportunity to correct this factor with the actuation "service interval setting".