Data Monitor

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item (Unit)	Remarks
WARNING LAMP (On/Off)	Hybrid EPS (Electrical Power Steering) warning lamp control status is displayed.
STEERING ANGLE SENSOR STATUS (Abnormal/Normal)	Steering angle sensor malfunction status is displayed from steering angle sensor via CAN communication.
HEV/ENGINE STATUS (STOP/RUN)	Hybrid system start status is displayed from HPCM via CAN communication.
FLOW CONNECTION VALVE (OPEN/CLOSE)	Displays the open/close status for flow connection valve.
BATTERY VOLT (V)	Displays the power supply voltage for power steering control module.
STEERING TORQUE (Nm)	Steering wheel turning force is displayed from torque sensor via CAN communication.
STEERING ANGLE SIGNAL (deg)	Steering angle value is displayed from steering angle sensor via CAN communication.
STEERING ANGLE SPEED (deg/s)	Displays the steering angle speed calculated by the power steering control module.
MOTOR CURRENT (A)	Displays the current value consumed by power steering motor.
MOTOR TORQUE COMMAND (Nm)	Displays a target torque value of the power steering motor.
ASSIST LEVEL (%)	Assist limit value is displayed for power steering motor. ^*1
VEHICLE SPEED (km/h or mph)	Vehicle speed is displayed from combination meter via CAN communication. ^*2
MOTOR REVOLUTION SPEED (rpm)	Displays the revolutions for power steering motor.
CONTROL MODULE ESTM TEMP (deg.C or deg.F)	Displays a power steering motor drive circuit temperature estimated by the control module.
HEAT PROTCT STATUS (NORMAL/PRTECT)	Displays a heat protection status by power steering oil pump assembly

*1: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls However, it returns to 100% when left standing.

*2: It is not a malfunction, though it might not be corresponding just after ignition switch in turned ON.