Work Procedure: ECM

WARNING: This page is about a different variant/trim than selected.

PERFORM CONFIGURATION
With CONSULT
1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Perform configuration according to the CONSULT display.
4. Select the "Manual Configuration". (If necessary)
5. Perform configuration according to the CONSULT display.
GO TO 2.
CHECK DTC
With CONSULT
1. Turn ignition switch OFF and wait for 10 seconds or more.
2. Turn ignition switch ON.
3. Perform self-diagnosis.
4. Check that no DTC is detected.
WORK END