Inspection After Disassembly

Drive Gear and Drive Pinion 

• Clean up the disassembled parts.
• If the gear teeth never mesh or line-up correctly, determine the cause and adjust or replace as necessary.
• If the gears are worn, cracked, damaged, pitted or chipped (by friction) noticeably, replace with new drive gear and drive pinion as a set.

Bearing 

• Clean up the disassembled parts.
• If any chipped (by friction), pitted, worn, rusted or scratched marks, or unusual noise from the bearing is observed, replace as a bearing assembly (as a new set).

Side Gear and Pinion Mate Gear 

• Clean up the disassembled parts.
• If any cracks or damage on the surface of the tooth is found, replace.
• If any worn or chipped mark on the contact sides of the thrust washer is found, replace.

Side Gear Thrust Washer and Pinion Mate Thrust Washer 

• Clean up the disassembled parts.
• If it is chipped (by friction), damaged, or unusually worn, replace.

Oil Seal 

• Whenever disassembled, replace.
• If wear, deterioration of elasticity (sealing force lips), or damage is detected on the lips, replace them.

Differential Case 

• Clean up the disassembled parts.
• If any wear or crack on the contact sides of the differential case is found, replace.