LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> QX80 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Driver Assistance System (ADAS Control Unit) (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC C1A13: Stop Lamp Relay >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX80. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK DTC PRIORITY

    If DTC "C1A13" is displayed with DTC "U1000", first diagnose the DTC "U1000".

    Is applicable DTC detected?

    YES 

    Perform diagnosis of applicable. Refer to DTC LOGIC .

    NO 

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE (1)

    1. Start the engine.
    2. Perform the active test item "STOP LAMP" with CONSULT.
    3. Perform "All DTC Reading".
    4. Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".

    Is "C1A13" detected as the current malfunction?

    YES 

    Refer to DIAGNOSIS PROCEDURE .

    NO 

    GO TO STEP 3. 

  3. PERFORM DTC CONFIRMATION PROCEDURE (2)

    1. Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 20 seconds or more without the brake pedal depressed.
      CAUTION:

      Always drive safely.

      NOTE:

      If it is outside the above condition, repeat step 1.

    2. Perform "All DTC Reading".
    3. Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".

    Is "C1A13" detected as the current malfunction?

    YES 

    Refer to DIAGNOSIS PROCEDURE .

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals