Additional Service When Replacing Control Unit: Description
Each function is reset to the following condition when the Driver Seat Control Unit is replaced.
Refer to SPECIAL REPAIR REQUIREMENT .
| Function | Condition | Procedure |
|---|---|---|
| Memory (Seat, Steering, Mirror) | Erased | Perform storing |
| Entry/Exit Assist | OFF | Perform initialization |
| Set slide amount*1 | ||
| Intelligent Key Interlock | Erased | Perform storing |
| Seat Synchronization | OFF | - |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.