Diagnostic Test

1. Turn ignition switch OFF.
2. Remove EVAP control system pressure sensor with its harness connector.
   NOTE:

   Always replace O-ring with a new one.

3. Install a vacuum pump to EVAP control system pressure sensor.
4. Turn ignition switch ON and check output voltage between ECM harness connector terminals as follows.

   ECM			Condition (Applied vacuum)	Voltage
   Connector	+	-
   	Terminal	Terminal
   E16	121	148	Not applied	0.5 - 4.6 V
   			-26.7 kPa (-0.267 bar, -0.272 kg/cm2 , -3.87 psi)	2.1 to 2.5 V lower than above value

   CAUTION:

   • Always calibrate the vacuum pump gauge when using it.
   • Never apply below - 93.3 kPa (-0.933 bar, - 0.952 kg/cm² , - 13.53 psi) or pressure over 106.7 kPa (1.067 bar, 1.088 kg/cm² , 15.47 psi).

Is the inspection result normal?

YES 

INSPECTION END

NO 

Replace EVAP control system pressure sensor. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .