Diagnostic Test

With CONSULT

1. Perform "All DTC reading".
2. Check DTC of "TRANSMISSION".

Is the DTC related to "communication error with ECM" detected?

YES 

GO TO STEP 2  .

NO 

Replace ECM. Refer to REMOVAL AND INSTALLATION .

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Disconnect TCM harness connector.
4. Check the continuity between ECM harness connector and TCM harness connector.

   +		-		Continuity
   ECM		TCM
   Connector	Terminal	Connector	Terminal
   E48	138	E47	3	Existed
   	151		1

5. Also check harness for short to battery and short to ground.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Repair or replace error-detected parts.

With CONSULT

1. Replace ECM. Refer to REMOVAL AND INSTALLATION .
2. Turn ignition switch ON and wait at least 5 seconds.
3. Check "Self-diagnostic result" of "ENGINE".

Is DTC "P0702" detected again?

YES 

Replace TCM. Refer to REMOVAL AND INSTALLATION .

NO 

INSPECTION END