Diagnostic Test

With CONSULT 

1. Turn the ignition switch OFF to ON.
2. Perform "CHASSIS CONTROL" self-diagnosis. Refer to CONSULT FUNCTION (CHASSIS CONTROL) .

Is any DTC detected?

YES 

Check the DTC. Refer to DTC INDEX .

NO 

GO TO STEP 2. 

1. Turn the ignition switch OFF.
2. Disconnect chassis control module harness connector.
3. Disconnect power steering control module harness connector.
4. Check the connector for disconnection or looseness.
5. Check the pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

Repair or replace harness, connector, or terminal, securely lock the connector.

With CONSULT 

1. Connect chassis control module harness connector.
2. Connect power steering control module harness connector.
3. Turn the ignition switch OFF to ON.
4. Erase self-diagnostic results for "EPS/DAST 3".
5. Turn the ignition switch OFF and wait for at least 10 seconds.
6. Turn the ignition switch OFF to ON.
7. Perform self-diagnosis for "EPS/DAST 3".

Is DTC "U140E" detected?

YES 

Power steering control module is malfunctioning. Replace steering gear assembly. Refer to REMOVAL AND INSTALLATION .

NO 

Check pin terminal and connection of each harness connector for malfunctioning conditions.