LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q60 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Transfer Case) >> Unit Disassembly And Assembly >> Main Shaft >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Separate front case and rear case, then remove main shaft assembly. Refer to DISASSEMBLY AND ASSEMBLY .
  2. Remove snap ring WHITE-1 from main shaft.
    G05979424Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove spacer WHITE-1 and steel ball WHITE-2 from main shaft.
    G05979425Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Be careful not to drop the steel ball.

  4. Using a press, remove electric controlled coupling from main shaft.
    G05979426Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove circlip WHITE-1 from notch MARU-A-W of electric controlled coupling.
    G05979441Courtesy of NISSAN NORTH AMERICA, INC.
    ARROW : Front side
    CAUTION:
    • Never remove the circlip from the electric controlled coupling rear side.
    • Never damage electric control coupling spline, bush, etc.
  6. Remove snap ring from main shaft.
  7. Remove spacer WHITE-1 and steel ball WHITE-2 from main shaft.
    G05979428Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Be careful not to drop the steel ball.

  8. Remove sprocket from main shaft.
  9. Remove needle bearing from main shaft.
  10. Perform inspection after disassembly. Refer to INSPECTION .
scientia non olet · About LEMON Manuals