Disassembly And Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Install needle bearing to main shaft.
CAUTION:
Apply transfer fluid to the periphery of needle bearing.
Install sprocket to main shaft.
Install spacer and steel ball to main shaft.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION:
Be careful not to drop the steel ball.
Install snap ring to main shaft.
CAUTION:
Never reuse snap ring.
Install circlip to notch of the electric controlled coupling.

Courtesy of NISSAN NORTH AMERICA, INC.

: Front side
CAUTION:
- Never install the circlip to the notches other than notch .
- Never install the circlip from the electric controlled coupling rear side.
- Never reduce the outer diameter of circlip to less than 43.2 mm (1.701 in).
- Never damage electric control coupling spline, bush, etc.
- Never reuse circlip.
- Never reuse O-ring of AWD solenoid harness connector. When replace it, replace electric controlled coupling.
Install electric controlled coupling to main shaft.
CAUTION:
Securely insert it until locked.
Install spacer and steel ball to main shaft.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION:
Be careful not to drop the steel ball.
Install snap ring to main shaft.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION:
Never reuse snap ring.
Install main shaft assembly to rear case, then install front case and rear case. Refer to DISASSEMBLY AND ASSEMBLY .