LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q60 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Transfer Case) >> System Description >> Diagnosis System (AWD Control Unit) >> Consult Function >> Data Monitor

Data Monitor

WARNING: This page is about a different variant/trim than selected.
NOTE:

The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item (Unit) Remarks
STOP LAMP SW (On/Off) Stop lamp switch signal status via CAN communication line is displayed.
ENG SPEED SIG (Run/Stop) Engine status is displayed.
ETS ACTUATOR (On/Off) Operating condition of AWD actuator relay (integrated in AWD control unit) is displayed.
4WD WARN LAMP (On/Off) Control status of AWD warning (on information display) is displayed.
4WD MODE SW (##) Mode switch status is displayed.
(This item is not equipped, but displayed.)
4WD MODE MON (AUTO) Control status of AWD is displayed.
DIS-TIRE MONI (mm) Improper size tire installed condition is displayed.
P BRAKE SW (On/Off) Parking brake switch signal status via CAN communication line is displayed.
BATTERY VOLT (V) Power supply voltage for AWD control unit.
THRTL POS SEN (%) Throttle opening status is displayed.
ETS SOLENOID (A) Monitored value of current at AWD solenoid.
FR RH SENSOR (km/h or mph) Wheel speed calculated by front RH wheel sensor signal is displayed.
FR LH SENSOR (km/h or mph) Wheel speed calculated by front LH wheel sensor signal is displayed.
RR RH SENSOR (km/h or mph) Wheel speed calculated by rear RH wheel sensor signal is displayed.
RR LH SENSOR (km/h or mph) Wheel speed calculated by rear LH wheel sensor signal is displayed.