LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 448 (Fuel System (2.0L)) >> Removal And Installation >> Fuel Level Sensor Unit And Fuel Pump Assembly >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2019 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.

Note to the following, and install in the reverse order of removal.

  1. Check for damage of main fuel level sensor unit installation position on the side of adapter.
  2. Slide main fuel level sensor unit aligns to installation groove, then insert it until it stops.
    • After inserting, apply force in reverse direction (removal direction) to ensure it cannot be pulled out.
  3. Connect the harness connector.
scientia non olet · About LEMON Manuals