LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 83 (Driver Assistance System (ADAS Control Unit) (Introduction & Removal And Installation) (Hybrid)) >> Basic Inspection >> Configuration (ADAS Control Unit) >> Work Procedure

Work Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Use "Manual Configuration" only when "Type ID" of ADAS control unit cannot be read.
  • If an error occurs during configuration, start over from the beginning.

  1. CHECKING TYPE ID

    G-20 WITH CONSULT

    1. Select "Before Replace ECU" of "Read/Write Configuration".
    2. Check that "Type ID" is displayed on CONSULT.

    Is "Type ID" displayed?

    YES 

    GO TO STEP 2  .

    NO 

    GO TO STEP 6  .

  2. VERIFYING TYPE ID (1)

    G-20 WITH CONSULT

    Compare a "Type ID" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

    NOTE:

    For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

    GO TO STEP 3  .

  3. SAVING TYPE ID

    G-20 WITH CONSULT

    Save "Type ID" on CONSULT.

    GO TO STEP 4  .

  4. REPLACE ADAS CONTROL UNIT (1)

    Replace ADAS control unit. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 5  .

  5. WRITING (AUTOMATIC WRITING)

    G-20 WITH CONSULT

    1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
    2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue) to write the "Type ID" into the ADAS control unit.

    GO TO STEP 8  .

  6. REPLACE ADAS CONTROL UNIT (2)

    Replace ADAS control unit. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 7  .

  7. WRITING (MANUAL WRITING)

    G-20 WITH CONSULT

    1. Select "Manual Configuration".
    2. Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the ADAS control unit.
      NOTE:

      For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

    GO TO STEP 8  .

  8. VERIFYING TYPE ID (2)

    G-20 WITH CONSULT

    Compare a "Type ID" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

    NOTE:

    For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

    GO TO STEP 9  .

  9. OPERATION CHECK

    Confirm that each function controlled by ADAS control unit operates normally.

    WORK END

scientia non olet · About LEMON Manuals