LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX80 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case) >> Unit Removal And Installation >> Transfer Assembly >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove rear propeller shaft. Refer to REMOVAL AND INSTALLATION .
  2. Remove front propeller shaft. Refer to REMOVAL AND INSTALLATION .
  3. Disconnect transfer control actuator, transfer rotary position sensor, transfer lock position sensor, transfer Hi-Lo position sensor and transfer fluid temperature sensor harness connectors and separate harnesses from transfer assembly.
  4. Remove transfer breather hose.
  5. Remove exhaust front tube (LH) with a power tool. Refer to REMOVAL AND INSTALLATION .
  6. Remove exhaust front tube (RH) with a power tool. Refer to REMOVAL AND INSTALLATION .
  7. Remove main muffler with a power tool. Refer to REMOVAL AND INSTALLATION .
  8. Support transfer assembly and transmission assembly with a jack.
    CAUTION:

    Secure transfer assembly and transmission assembly to a jack.

  9. Remove rear engine mounting member and engine mounting insulator with a power tool. Refer to REMOVAL AND INSTALLATION .
  10. Lower jack to the position where the top transfer mounting bolts can be removed.
  11. Remove transfer mounting bolts and separate transfer from transmission.
    CAUTION:

    Secure transfer assembly and transmission assembly to a jack.

scientia non olet · About LEMON Manuals