Diagnostic Test

1. Turn the ignition switch OFF.
2. Disconnect power steering control unit harness connector.
3. Check the voltage between power steering control unit harness connector and ground.

   Power steering control unit		-	Voltage
   Connector	Terminal
   M108	3	Ground	0 V

4. Turn the ignition switch ON.
   CAUTION:

   Never start the engine.

5. Check the voltage between power steering control unit harness connector and ground.

   Power steering control unit		-	Voltage
   Connector	Terminal
   M108	3	Ground	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 2. 

NO 

Check the following. If any items are damaged, repair or replace damaged parts.

• 10A fuse (#45) open
  1. Harness for short or open between ignition switch and power steering control unit harness connector No. 3 terminal.
  2. Ignition switch. Refer to COMPONENT INSPECTION .

1. Turn the ignition switch OFF.
2. Check the continuity between power steering control unit harness connector and ground.

   Power steering control unit		-	Continuity
   Connector	Terminal
   M108	6	Ground	Existed

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

Repair or replace error-detected parts.

Check the power steering control unit pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair or replace error-detected parts.