Precautions for Removing of Battery Terminal

• When removing the 12V battery terminal, turn OFF the ignition switch and wait at least 30 seconds.

NOTE: ECU may be active for several tens of seconds after the ignition switch is turned OFF. If the battery terminal is removed before ECU stops, then a DTC detection error or ECU data corruption may occur.

Fig 1: Removing Battery Negative Terminal

Courtesy of NISSAN NORTH AMERICA, INC.

• For vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON the ignition switch.

NOTE: If the ignition switch is turned ON with any one of the terminals of main battery and sub battery disconnected, then DTC may be detected.

• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
  NOTE: The removal of 12V battery may cause a DTC detection error.