Wake-up operation

BCM changes from the low power consumption mode to the CAN communication sleep mode when the any of the BCM wake-up conditions is fulfilled. Only the control with BCM is activated.
BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions is fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the unified meter and A/C amp. transmits the wake up signal to BCM via CAN communication to report the CAN communication start.

WAKE-UP CONDITION

BCM wake-up condition	CAN wake-up condition
Trunk lid opener switch: OFF → ON Power window switch and retractable hard top control unit communication: Receiving Remote keyless entry receiver communication: Receiving	Receiving the sleep-ready signal (Not-ready) from any units Key slot (key switch): OFF → ON, ON → OFF Push-button ignition switch (push switch): OFF→ ON Hazard switch: OFF → ON PASSING switch: OFF → ON, ON → OFF TAIL LAMP switch: OFF → ON Driver door switch: OFF → ON, ON → OFF Passenger door switch: OFF → ON, ON → OFF Trunk room lamp switch: OFF → ON, ON → OFF Driver door request switch: OFF → ON Passenger door request switch: OFF → ON Trunk lid opener request switch: OFF → ON Stop lamp switch: ON ICC brake hold relay (with ICC): ON Clutch interlock switch: OFF → ON

BCM wake-up condition

CAN wake-up condition

Trunk lid opener switch: OFF → ON
Power window switch and retractable hard top control unit communication: Receiving
Remote keyless entry receiver communication: Receiving