DTC Confirmation Procedure

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

: GO TO 2.

With CONSULT 

1. Turn ignition switch ON.
2. Select "SLCT LVR POSI" and "MANU MODE SW" in "Data Monitor" in "TRANSMISSION".
3. Maintain the following each conditions more than 2 seconds.

   SLCT LVR POSI: D

   MANU MODE SW: ON

4. Perform "Self Diagnostic Results" in "TRANSMISSION".

   Is "P1815" detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END