Component Inspection (High Pressure Fuel Pump)

1. Turn ignition switch OFF.
2. Disconnect high pressure fuel pump harness connector.
3. Check the resistance between high pressure fuel pump terminals.

   +	-	Condition		Resistance (Approx.)
   High pressure fuel pump
   Terminal
   1	2	Temperature °C (°F)	20 - 30 (68 - 86)	9 - 11 Ω

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Replace high pressure fuel pump. Refer to "REMOVAL AND INSTALLATION ".

WITH CONSULT

1. Reconnect high pressure fuel pump harness connector.
2. Start the engine.
3. Check "FUEL PRES SEN V" in "DATA MONITOR" mode of "ECM" using CONSULT.

   Monitor item	Condition	Value (Approx.)
   FUEL PRES SEN V	Engine speed: idle	820 - 1, 220 mV
   	Engine speed: Revving engine from idle to 4, 000 rpm quickly	820 - 3, 060 mV

WITHOUT CONSULT

1. Reconnect high pressure fuel pump harness connector.
2. Start the engine.
3. Check FRP sensor signal voltage.

   ECM			Condition	Value (Approx.)
   Connector	+	-
   	Terminal
   F110	31	40	Engine speed: idle	0.82 - 1.22 V
   			Engine speed: Revving engine from idle to 4, 000 rpm quickly	0.82 - 3.06 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Replace high pressure fuel pump. Refer to "REMOVAL AND INSTALLATION ".