Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• Do not damage engine mounting insulator and do not spill oil on it.
• For a location with a positioning pin, insert it securely into hole of mating part.
• For a part with a specified installation orientation, refer to component figure in "EXPLODED VIEW ".
• When installing engine mounting bracket (RH and LH) on cylinder block, tighten two upper bolts [shown as (B) in the figure below] first. Then tighten two lower bolts [shown as (C) in the figure below].
  Fig 1: Locating Engine Mounting Bracket Upper And Lower Bolts

  Courtesy of NISSAN NORTH AMERICA, INC.
• Check that all engine mounting insulators are seated properly, then tighten mounting nuts.
• Tighten rear engine mounting member bolts in numerical order as shown in the figure below.
  Fig 2: Locating Rear Engine Mounting Member Mounting Bolts With Tightening Sequence

  Courtesy of NISSAN NORTH AMERICA, INC.