DTC Confirmation Procedure

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is 11 V or more at idle. 

: GO TO 2.

1. Start engine and warm it up to the normal operating temperature.
2. Keep the engine speed approximately 1, 000 rpm at no load.
3. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES: Proceed to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END