Diagnosis Procedure
- CHECK DTC WITH COMBINATION METER
Refer to "CONSULT FUNCTION ".
Is the inspection result normal?
YES: GO TO 2.
NO: Proceed to "COMPONENT FUNCTION CHECK ".
- CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect "fuel level sensor unit and fuel pump" harness connector.
- Turn ignition switch ON.
- Check the voltage between "fuel level sensor unit and fuel pump" harness connector and ground.
Fuel level sensor unit and fuel pump Ground Voltage (V) Connector Terminal C5 4 Ground Approx. 5 Is the inspection result normal?
YES: GO TO 4.
NO: GO TO 3.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness for open or short between ECM and "fuel level sensor unit and fuel pump"
- Loose or poor connection for each connector and harness
: Repair open circuit, short to ground or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector.
- Check the continuity between "fuel level sensor unit and fuel pump" harness connector and "combination meter" harness connector.
Fuel level sensor unit and fuel pump Combination meter Continuity Connector Terminal Connector Terminal C5 5 M34 24 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 6.
NO: GO TO 5.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness for open or short between "fuel level sensor unit and fuel pump" and "combination meter"
- Loose or poor connection for each connector and harness
: Repair open circuit, short to ground or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR
Refer to "COMPONENT INSPECTION (FUEL TANK TEMPERATURE SENSOR) ".
Is the inspection result normal?
YES: GO TO 7.
NO: Replace "fuel level sensor unit and fuel pump". Refer to "REMOVAL AND INSTALLATION ".
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT "
: INSPECTION END