Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2013 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

Install O-ring to oil pump cover.
CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
Fig 1: Removing/Installing Oil Pump Cover O-Ring
Courtesy of NISSAN NORTH AMERICA, INC.
Install O-ring to oil pump housing.
CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
Fig 2: Removing/Installing Oil Pump Housing O-Ring
Courtesy of NISSAN NORTH AMERICA, INC.
Install oil pump housing oil seal to the oil pump housing until it is flush using Tool.
Tool number: ST33400001 (J-26082)
CAUTION:
- Do not reuse oil seal.
- Apply ATF to oil seal.
Fig 3: Installing Oil Seal To Oil Pump Housing
Courtesy of NISSAN NORTH AMERICA, INC.
After temporarily tightening the bolts for the oil pump housing to the oil pump cover, tighten them to the specified torque in the sequence shown below.
Oil pump housing bolts: 9.0 N.m (0.92 kg-m, 80 in-lb.)

Fig 4: Oil Pump Housing Bolt Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.