| VHCL/S SE-A/T |
(km/h or mph) |
Displays the vehicle speed calculated by the TCM from the output shaft revolution. |
| ESTM VSP SIG |
(km/h or mph) |
Displays the vehicle speed signal received via HEV system CAN. |
| OUTPUT REV |
(RPM) |
Displays the output speed calculated from the pulse signal of output speed sensor. |
| INPUT SPEED |
(RPM) |
Displays the input speed calculated from front sun gear revolution and front carrier revolution. |
| F SUN GR REV |
(RPM) |
Displays the front sun gear revolution calculated from the pulse signal of input speed sensor 1. |
| F CARR GR REV |
(RPM) |
Displays the front carrier gear revolution calculated from the pulse signal of input speed sensor 2. |
| ACCELE POSI |
(0.0/8) |
Displays the accelerator position estimated value received via HEV system CAN. |
| THROTTLE POSI |
(0.0/8) |
Displays the throttle position received via HEV system CAN. |
| ATF TEMP 1 |
(°C or °F) |
Displays the ATF temperature of oil pan calculated from the signal voltage of A/T fluid temperature sensor. |
| ATF TEMP SE 1 |
(V) |
Displays the signal voltage of A/T fluid temperature sensor. |
| BATTERY VOLT |
(V) |
Displays the power supply voltage of TCM. |
| LINE PRES SOL |
(A) |
Displays the command current from TCM to the line pressure solenoid. |
| L/B SOLENOID |
(A) |
Displays the command current from TCM to the low brake solenoid. |
| FR/B SOLENOID |
(A) |
Displays the command current from TCM to the front brake solenoid. |
| HLR/C SOL |
(A) |
Displays the command current from TCM to the high and low reverse clutch solenoid. |
| I/C SOLENOID |
(A) |
Displays the command current from TCM to the input clutch solenoid. |
| D/C SOLENOID |
(A) |
Displays the command current from TCM to the direct clutch solenoid. |
| 2346/B SOL |
(A) |
Displays the command current from TCM to the 2346 brake solenoid. |
| L/P SOL MON |
(A) |
Monitors the command current from TCM to the line pressure solenoid, and displays the monitor value. |
| L/B SOL MON |
(A) |
Monitors the command current from TCM to the low brake solenoid, and displays the monitor value. |
| FR/B SOL MON |
(A) |
Monitors the command current from TCM to the front brake solenoid, and displays the monitor value. |
| HLR/C SOL MON |
(A) |
Monitors the command current from TCM to the high and low reverse clutch solenoid, and displays the monitor value. |
| I/C SOL MON |
(A) |
Monitors the command current from TCM to the input clutch solenoid, and displays the monitor value. |
| D/C SOL MON |
(A) |
Monitors the command current from TCM to the direct clutch solenoid, and displays the monitor value. |
| 2346/B SOL MON |
(A) |
Monitors the command current from TCM to the 2346 brake solenoid, and displays the monitor value. |
| GEAR RATIO |
Displays the gear ratio calculated from input speed and output speed. |
| INPUT TRQ S |
(Nm) |
Displays the input torque using for the oil pressure calculation process of shift change control. |
| INPUT TRQ L/P |
(Nm) |
Displays the input torque using for the oil pressure calculation process of line pressure control. |
| TRGT PRES L/B |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of low brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRE FR/B |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of front brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRG PRE HLR/C |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of high and low reverse clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRES I/C |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of input clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRGT PRES D/C |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of direct clutch solenoid valve calculated by the oil pressure calculation process of shift change control. |
| TRG PRE 2346/B |
(kPa, kg/cm2
or psi) |
Displays the target oil pressure value of 2346 brake solenoid valve calculated by the oil pressure calculation process of shift change control. |
| SHIFT PATTERN |
Displays the gear change data using the shift pattern control. |
| VEHICLE SPEED |
(km/h or mph) |
Displays the vehicle speed for control using the control of TCM. |
| G SEN SLOPE |
(%) |
Displays the inclination angle calculated by the G sensor signal received via HEV system CAN. |
| RANGE SW 4 |
(ON/OFF) |
Displays the operation status of transmission range switch 4. |
| RANGE SW 3 |
(ON/OFF) |
Displays the operation status of transmission range switch 3. |
| RANGE SW 2 |
(ON/OFF) |
Displays the operation status of transmission range switch 2. |
| RANGE SW 1 |
(ON/OFF) |
Displays the operation status of transmission range switch 1. |
| SFT DWN ST SW |
(ON/OFF) |
Displays the operation status of paddle shifter (down switch). |
| SFT UP ST SW |
(ON/OFF) |
Displays the operation status of paddle shifter (up switch). |
| DOWN SW LEVER |
(ON/OFF) |
Displays the operation status of selector lever (down switch). |
| UP SW LEVER |
(ON/OFF) |
Displays the operation status of selector lever (up switch). |
| NON M-MODE SW |
(ON/OFF) |
Displays whether the selector lever is in any position other than manual shift gate position. |
| MANU MODE SW |
(ON/OFF) |
Displays whether the selector lever is in the manual shift gate position. |
| TOW MODE SW |
(ON/OFF) |
- Displays the reception status of tow mode switch signal received via HEV system CAN.
- Not mounted but displayed.
|
| DS RANGE |
(ON/OFF) |
- Displays whether it is the DS mode.
- Not mounted but displayed.
|
| 1 POSITION SW |
(ON/OFF) |
- Displays the reception status of 1 position switch signal received via HEV system CAN.
- Not mounted but displayed.
|
| OD CONT SW |
(ON/OFF) |
- Displays the reception status of overdrive control switch signal received via HEV system CAN.
- Not mounted but displayed.
|
| BRAKESW |
(ON/OFF) |
Displays the reception status of stop lamp switch signal received via HEV system CAN. |
| POWERSHIFT SW |
(ON/OFF) |
- Displays the reception status of POWER mode signal received via HEV system CAN.
- Not mounted but displayed.
|
| ASCD-OD CUT |
(ON/OFF) |
Displays the reception status of ASCD OD cancel request signal received via HEV system CAN. |
| ASCD-CRUISE |
(ON/OFF) |
Displays the reception status of ASCD operation signal received via HEV system CAN. |
| ABS SIGNAL |
(ON/OFF) |
Displays the reception status of ABS operation signal received via HEV system CAN. |
| TCS GR/P KEEP |
(ON/OFF) |
Displays the reception status of TCS gear keep request signal received via HEV system CAN. |
| TCS SIGNAL 2 |
(ON/OFF) |
Displays whether the reception value of A/T shift schedule change demand signal received via HEV system CAN is "cold". |
| TCS SIGNAL 1 |
(ON/OFF) |
Displays whether the reception value of A/T shift schedule change demand signal received via HEV system CAN is "warm". |
| LOW/B PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of low brake. |
| HC/IC/FRB PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of high and low reversed clutch, input clutch or front brake. |
| IC/FRB PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of input clutch or front brake. |
| HLR/C PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of high and low reversed clutch. |
| W/O THL POS |
(ON/OFF) |
Displays the kickdown condition signal status received via HEV system CAN. |
| CLSD THL POS |
(ON/OFF) |
Displays the idling status signal status received via HEV system CAN. |
| DRV CST JUDGE |
(DRIVE/COAST) |
Displays the judgment results of "driving" or "coasting" judged by TCM. |
| SHIFT IND SIGNAL |
Displays the transmission value of shift position signal transmitted via HEV system CAN. |
| F-SAFE IND/L |
(ON/OFF) |
Displays the transmission status of A/T CHECK indicator lamp signal transmitted via HEV system CAN. |
| ATF WARN LAMP |
(ON/OFF) |
- Displays the transmission status of ATF temperature signal transmitted via HEV system CAN.
- Not mounted but displayed.
|
| MANU MODE IND |
(ON/OFF) |
Displays the transmission status of manual mode signal transmitted via HEV system CAN. |
| ON OFF SOL MON |
(ON/OFF) |
Monitors the command value from TCM to the anti-interlock solenoid, and displays the monitor status. |
| ON OFF SOL |
(ON/OFF) |
Displays the command status from TCM to anti-interlock solenoid. |
| SLCT LVR POSI |
Displays the shift positions recognized by TCM. |
| GEAR |
Displays the current transmission gear position recognized by TCM. |
| NEXT GR POSI |
Displays the target gear position of gear change that is calculated based on the vehicle speed information and throttle information. |
| SHIFT MODE |
Displays the transmission driving mode recognized by TCM. |
| D/C PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of direct clutch. |
| FR/B PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of front brake. |
| 2346/B PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of 2346 brake. |
| 2346B/DC PARTS |
(FAIL/NOTFAIL) |
Displays whether the identified malfunction point judged by TCM is the related parts of 2346 brake or direct clutch. |
| SHIFT SCHEDULE |
Displays the shift schedule selected by TCM. |
| DRIVE MODE STATS |
Displays the drive mode status recognized by TCM. |
| SPORT MODE |
Displays the status of drive mode select switch signal received via HEV system CAN |
| STANDARD MODE |
| ECO MODE |
| SNOW MODE |
| DRIVE MOTOR REV |
(RPM) |
Displays the traction motor speed received via HEV system CAN. |
| CL1 SOLENOID |
(A) |
Displays the command current from TCM to the clutch 1 solenoid. |
| CL1 SOLENOID MONITOR |
(A) |
Monitors the command current from TCM to the clutch 1 solenoid, and displays the monitor value. |
| INPUT TORQUE |
(Nm) |
Displays the input torque received via HEV system CAN. |
| CL1 PRESSURE |
(kPa, kg/cm2
or psi) |
Displays the clutch 1 oil pressure command value received via HEV system CAN. |
| SUB E-OP PRESSURE |
(kPa, kg/cm2
or psi) |
Displays the oil pressure command value to sub electric oil pump transmitted via HEV system CAN. |
| SUB E-OP TORQUE |
(Nm) |
Displays the torque of sub electric oil pump received via HEV system CAN. |
| SUB E-OP REVOLUTION |
(RPM) |
Displays the revolution of sub electric oil pump received via HEV system CAN. |
| SUB E-OP STEP OUT |
(OK/NG) |
Displays the step out status of sub electric oil pump received via HEV system CAN. |
| SUB E-OP READY |
(READY/COMP) |
Displays the ready status of sub electric oil pump received via HEV system CAN. |
| SUB E-OP CAN DIAGNOSIS |
(OK/NG) |
Displays the CAN diagnosis permit status to sub electric oil pump transmitted via HEV system CAN. |
| SUB E-OP POWER SAVE |
(ON/OFF) |
Displays the output limit status of sub electric oil pump received via HEV system CAN. |
| SUB E-OP OPERATION REQ |
(ON/OFF) |
Displays the drive permit status of sub electric oil pump received via HEV system CAN. |
| SUB E-OP START REQUEST |
(ON/OFF) |
Displays the coercion drive request status of sub electric oil pump received via HEV system CAN. |
| SUB E-OP STOP REQUEST |
(ON/OFF) |
Displays the stop request status of sub electric oil pump transmitted via HEV system CAN. |
| TARGET DRIVE TORQUE |
(Nm) |
Displays the target drive torque of during change gear received via HEV system CAN. |
| CL2 TARGET TORQUE |
(Nm) |
Displays the target torque of clutch/brake of transmission received via HEV system CAN. |
| ENGINE CRANK |
(NOTCNK/CRANK) |
Displays the starting status of engine received via HEV system CAN. |
| ENGINE STATUS |
(STOP/RUN) |
Displays the engine status received via HEV system CAN. |