Inspection Mode 2

CHANGING TO INSPECTION MODE
◦ With CONSULT
1. Turn ignition switch OFF.
2. Select "INSPECTION MODE 2" in "ACTIVE TEST" mode of "EV/HEV".
3. Touch "ON".
4. The system changes to inspection mode 2, and the 12-volt battery charge warning lamp on the combination meter blinks.
5. Set the vehicle to READY.
ⓧ Without CONSULT
1. Perform the following steps within 60 seconds.
  - Turn ignition switch ON with the selector lever at the P position.
  - Fully depress the accelerator pedal, then fully release it 3 times.
  - While depressing the brake pedal, shift the select lever to the N position.
  - Fully depress the accelerator pedal, then fully release it 3 times.
  - While depressing the brake pedal, shift the select lever to the P position.
  - Fully depress the accelerator pedal, then fully release it 3 times.
2. The system changes to inspection mode 2, and the 12-volt battery charge warning lamp on the combination meter blinks.
3. Set the vehicle to READY.
  : END