Precautions for Harness Repair

WARNING: This page is about a different variant/trim than selected.

Solder the repaired area and wrap tape around the soldered area.
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

Fig 1: Identifying Soldered & Taped Repair Area
Courtesy of NISSAN NORTH AMERICA, INC.
Bypass connection is never allowed at the repaired area.
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Fig 2: Identifying Incorrect Bypass Connection
Courtesy of NISSAN NORTH AMERICA, INC.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.