Component Inspection (Stop Lamp Switch)
- CHECK STOP LAMP SWITCH-I
- Turn ignition switch OFF.
- Disconnect stop lamp switch harness connector.
- Check the continuity between stop lamp switch terminals under the following conditions.
Terminals Condition Continuity 3 and 4 Brake pedal Fully released Not existed Slightly depressed Existed Is the inspection result normal?
YES: INSPECTION END
NO: GO TO 2.
- CHECK STOP LAMP SWITCH-II
- Adjust stop lamp switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
- Check the continuity between stop lamp switch terminals under the following conditions.
Terminals Condition Continuity 3 and 4 Brake pedal Fully released Not existed Slightly depressed Existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace stop lamp switch. Refer to "EXPLODED VIEW ".