Component Inspection

1. CHECK THROTTLE POSITION SENSOR
   1. Turn ignition switch OFF.
   2. Reconnect all harness connectors disconnected.
   3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT ".
   4. Turn ignition switch ON.
   5. Set selector lever to D (A/T) or 1st (M/T) position.
   6. Check the voltage between ECM harness connector terminals as per the following.

      ECM			Condition		Voltage (V)
      Connector	+	-
      	Terminal	Terminal
      F101	30 [TP sensor 1 (bank 1)]	40	Accelerator pedal	Fully released	More than 0.36
      				Fully depressed	Less than 4.75
      	31 [TP sensor 1 (bank 2)]	48		Fully released	More than 0.36
      				Fully depressed	Less than 4.75
      	34 [TP sensor 2 (bank 1)]	40		Fully released	Less than 4.75
      				Fully depressed	More than 0.36
      	35 [TP sensor 2 (bank 2)]	48		Fully released	Less than 4.75
      				Fully depressed	More than 0.36

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: GO TO 2.

2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
   1. Replace malfunctioning electric throttle control actuator. Refer to "EXPLODED VIEW ".
   2. Go to "SPECIAL REPAIR REQUIREMENT ".

INSPECTION END