DTC Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to D position (A/T) or 1st position (M/T) and wait at least 3 seconds.
- Shift selector lever to P position (A/T) or Neutral position (M/T).
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to D position (A/T) or 1st position (M/T) and wait at least 3 seconds.
- Shift selector lever to P position (A/T) or Neutral position (M/T).
- Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
- Check DTC.
Is DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to D position (A/T) or 1st position (M/T) and wait at least 3 seconds.
- Shift selector lever to P position (A/T) or Neutral position (M/T).
- Start engine and let it idle for 3 seconds.
- Check DTC.
Is DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END