Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• Do not damage engine mounting insulator and do not spill oil on it.
• For a location with a positioning pin, insert it securely into hole of mating part.
• For a part with a specified installation orientation, refer to component figure in " EXPLODED VIEW  "  .
• When installing engine mounting bracket (RH and LH) on cylinder block, tighten two upper bolts [shown as (B) in the figure] first.

  Then tighten two lower bolts [shown as (C) in the figure].

  Fig 1: Identifying Engine Mounting Bracket Upper And Lower Mounting Bolts

  Courtesy of NISSAN NORTH AMERICA, INC.
• Check that all engine mounting insulators are seated properly, then tighten mounting nuts.
• Tighten rear engine mounting member bolts in numerical order as shown in the figure.

Fig 2: Rear Engine Mounting Member Bolts Tightening Sequence

Courtesy of NISSAN NORTH AMERICA, INC.