LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2012 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Parking Brake System) >> Ecu Diagnosis Information >> Electric Parking Brake Control Module >> Reference Value >> Consult Data Monitor Standard Value

Consult Data Monitor Standard Value

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
MONITOR ITEM REFERENCE

Monitor item Condition Reference values in normal operation
STATIC OPE FREQUENCY Always Times applied while vehicle stopped
DYNAMIC OPE FREQUENCY Always Times applied while vehicle being driven
TENSION SENSOR 1(1) Always 0.35 - 4.5 V
TENSION SENSOR 2(1) Always 0.35 - 4.5 V
POWER SUPPLY VOLTAGE Always 11 - 14 V
TENSION SEN 1 MONITOR(1) Always 0 - 1500 N
TENSION SEN 2 MONITOR(1) Always 0 - 1500 N
TARGET LOAD Always 0 - 1040 N
BRAKE SWITCH Pull the parking brake switch ON
Other than the above OFF
RELEASE SWITCH Press the parking brake switch ON
Other than the above OFF
ANALOG SWITCH Active (When battery voltage is 11 - 16 V) 0 - 0.8 V
Not activated (When battery voltage is 11 - 16 V) 2.8 - 5.5 V
MALFUNCTION STATUS Normal NORMAL
When there is a malfunction with some functions DEFECT
When the system cannot operate SEVERE
PARKING BRAKE STATUS Unconfirmed NO DTR
Released status RELEAS
Operation status LOCK
Operate DR LCK
Being released DR RLS
IGNITION SWITCH FROM IPDM When the power switch is ON ON
Other than when power switch is ON OFF
BRAKE SWITCH FROM BCM Brake pedal depressed On
Brake pedal not depressed Off
When there is a stop lamp switch malfunction INVALID
WHEEL SENSOR REAR RH Vehicle stopped 0.00 RPM
While driving(2) Almost same reading as speedometer (within ±10%)
WHEEL SENSOR REAR LH Vehicle stopped 0.00 RPM
While driving(2) Almost same reading as speedometer (within ±10%)
DECEL G SENSOR Vehicle stopped Approx. 0 G
During acceleration Positive value
During deceleration Negative value
VEHICLE SPEED When stopped 0.00 km/h
While driving(2) Almost same reading as speedometer (within ±10%)
ACCELE OPEN ANGLE Do not depress the accelerator pedal (power switch ON) 0%
Depress the accelerator pedal (power switch ON) 0 - 100%
ENGINE STATUS When the traction motor is stopped STOP
When the traction motor is operating Run
DIAG PROHIBIT When diagnostic allowed On
When diagnostic prohibited Off
SHIFT RANGE When there is a sift position signal malfunction LIMP
When in the P position P
When in the R position R
When in the N position N
When in the D position D
BUCKLE SWITCH When the seat belt (driver side) is fastened ON
When the seat belt (driver side) is not fastened OPEN
(1) The tension sensor has the tension sensor 1 and tension sensor 2 circuits.
(2) Check that tire pressure is standard value.