Inspection Procedure
WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- Precautions: Refer to PRECAUTION FOR LDW/LDP SYSTEM SERVICE .
- for LDW: Refer to SYSTEM DESCRIPTION .
- for LDP: Refer to SYSTEM DESCRIPTION .
- Normal operating condition: Refer to DESCRIPTION .
- ACTION TEST FOR LDW
- Drive the vehicle.
- Turn LDW switch ON (LDW ON indicator is ON).NOTE: LDP system is OFF.
- Check the LDW operation according to the following table.LDW OPERATION
Input Output Vehicle speed [Km/h (MPH)] Vehicle condition/Driver's operation Action LDW ON indicator Indication on the combination meter Buzzer Less than 64 (40) Close to lane marker No action ON OFF - 72 (45) or more Close to lane marker Warning - Buzzer sounds
- Warning lamp blinks
ON Short continuous beeps - Close to lane marker
- Turn signal ON (Deviate side)
No action ON OFF -
GO TO 2.
- ACTION TEST FOR LDP
- Turn LDP ON switch ON (LDP ON indicator lamp is ON).NOTE: LDW system is OFF.
- Check the LDP operation according to the following table.LDP OPERATION
Input Output Vehicle speed [Km/h (MPH)] Vehicle condition/Driver's operation Action Indication on the combination meter Buzzer Less than 64 (40) Close to lane marker No action - 72 (45) or more Close to lane marker Warning and yawing - Buzzer sounds
- Warning lamp blinks
- Brake control
Short continuous beeps - Close to lane marker
- Turn signal ON (Deviate side)
No action - Close to lane marker with soft braking Warning - Buzzer sounds
- Warning lamp blinks
Short continuous beeps VDC OFF switch:
OFF => ONCancellation - Buzzer sounds
- Indicator lamp blinks
NOTE: When LDP ON switch is ON ==> OFF, indicator lamp is turned OFF.Beep Snow mode switch:
OFF ==> ON
(If equipped)Cancellation - Buzzer sounds
- Indicator lamp blinks
NOTE: When LDP ON switch is ON ==> OFF, indicator lamp is turned OFF.Beep
- Turn LDP ON switch ON (LDP ON indicator lamp is ON).