DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

Go to 2.
CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI", "GEAR", "VHCL/S SE-A/T", "W/O THL POS" and "ENGINE SPEED" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
  CAUTION: Keep the same gear position.
  
  NOTE: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
  
  SLCT LVR POSI : D
  
  GEAR : 2nd, 3rd, 4th, 5th or 6th
  
  VHCL/S SE-A/T : More than 40 km/h (25 MPH)
  
  W/O THL POS : ON
  
  ENGINE SPEED : More than 1,500 RPM
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT-III".

Is "P0717" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END