Component Inspection

WITH CONSULT-III

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Select "DATA MONITOR" mode with CONSULT-III.
5. Check that the "L/FUEL PRES SEN V" value.
   DATA MONITOR ITEM CONDITION
   
   

   Data monitor item	Condition	Value (Approx.)
   L/FUEL PRES SEN V	Engine speed: idle	3, 000 -3, 300 mV
   	Engine speed: 3, 000 RPM (no load)

WITHOUT CONSULT-III

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Check low fuel pressure sensor signal voltage.
   VOLTAGE SPECIFICATION
   
   

   +		-	Condition	Value (Approx.)
   Low fuel pressure sensor		Ground
   Connector	Terminal
   F25	2	Ground	[Engine is running] Warm-up condition Idle speed	Courtesy of NISSAN MOTOR CO., U.S.A.
   			[Engine is running] Warm-up condition Engine speed: 2, 000 RPM	Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES: INSPECTION END.

   NO: Replace low fuel pressure sensor. Refer to "REMOVAL AND INSTALLATION ".