DTC Confirmation Procedure

PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
  
  GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Check 1st trip DTC.
  Is 1st trip DTC detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END