DTC Confirmation Procedure

PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
  
  GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine and let it idle for 10 second.
2. Keep the engine speed at approximately 3, 500 RPM for at least 10 seconds under no load.
3. Check DTC.
  Is DTC detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END