Work Step

When removing instrument panel assembly, combination meter, front display unit, AV control unit, instrument finisher A, instrument finisher B, and center console assembly take steps as per the order shown in the following chart.

WORK STEP REFERENCE

PARTS	INSTRUMENT PANEL ASSEMBLY	COMBINATION METER	FRONT DISPLAY UNIT	AV control unit	INSTRUMENT FINISHER A	INSTRUMENT FINISHER B	CENTER CONSOLE ASSEMBLY
Instrument lower cover	[1]		[1]	[1]		[1]	[1]
Glove box assembly	[2]					[2]
Front passenger air bag module harness connector	[3]					[3]
Front passenger air bag module mounting bolt	[4]					[4]
Selector lever knob	[5]		[2]	[2]		[5]	[2]
Console finisher assembly	[6]		[3]	[3]		[6]	[3]
Instrument center finisher RH	[7]		[4]	[4]		[7]	[4]
Front body side welt RH	[8]					[8]
Front pillar garnish RH	[9]					[9]
Speaker grille RH	[10]					[10]
Squawker RH	[11]					[11]
Front defroster grille RH	[12]					[12]
Front defroster grille LH	[13]					[13]
Instrument center finisher LH	[14]		[5]	[5]		[14]	[5]
Console rear finisher	[15]					[15]	[6]
Center console assembly	[16]					[16]	[7]
Front body side welt LH	[17]	[1]			[1]	[17]
Front pillar garnish LH	[18]					[18]
Speaker grille LH	[19]					[19]
Squawker LH	[20]					[20]
Instrument lower panel LH	[21]	[2]			[2]	[21]
Disconnect meter control switch harness connector	[22]	[3]			[3]	[22]
Driver air bag module	[23]					[23]
Steering wheel	[24]					[24]
Steering column cover	[25]					[25]
Combination switch	[26]					[26]
Spiral cable	[27]					[27]
Cluster lid A	[28]	[4]			[4]	[28]
Combination meter	[29]	[5]				[29]
Instrument finisher A					[5]
Upper ventilator grille	[30]					[30]
Center speaker	[31]					[31]
Cluster lid C	[32]		[6]	[6]		[32]
Cluster lid C lower	[33]			[7]		[33]
AV control unit	[34]			[8]		[34]
Cluster lid D	[35]		[7]			[35]
Front display unit	[36]		[8]			[36]
Instrument panel assembly mounting screws and bolts	[37]					[37]
Squawker LH harness clip	[38]					[38]
Instrument panel assembly	[39]					[39]
Instrument finisher B						[40]
[]:Number indicates step in removal procedures.

WARNING: Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more.

CAUTION: When removing, always use a remover tool that is made of plastic.