Removal and Installation: Installation

WARNING: This page is about a different car, the 2010 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal. For tightening torque, refer to "EXPLODED VIEW ".

Align the cam nut V-shaped groove with the holder V-guide (1). Install the cam nut to the holder guide.
CAUTION:
- Make sure cam nut is installed correctly to keep it from loosening.
- Replace intermediate shaft assembly if cam nut does not fit to the holder.
- Do not install the cam nut on the incorrect side.
  
  Fig 1: Identifying V-guide
  Courtesy of NISSAN MOTOR CO., U.S.A.
Install the intermediate shaft by pushing the holder pawl to the pinion shaft and sliding the intermediate shaft to (A).
CAUTION: Replace the intermediate shaft assembly if the pawl is deformed.

Fig 2: Identifying Intermediate Shaft Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
Install a new bolt and tighten to specification. Refer to "EXPLODED VIEW ".
CAUTION:
- Make sure cam nut contacts pinion shaft correctly.
- Make sure the holder is not deformed or interfering with the cam nut.
Install the cover (1) to the holder (2).
CAUTION:
- Align the cover groove with the holder guide.
- Make sure cover is installed correctly.
  
  Fig 3: Installing Cover And Holder
  Courtesy of NISSAN MOTOR CO., U.S.A.